Spintronics Community Forum

Incorrect Parts Listing for Challenge 130

A 1000 Ohm resistor is listed as an available part, and there is also a 1000 Ohm resistor shown in the starting setup as R1. There is only one 1000 Ohm resistor included with Acts 1 and Acts 2, so it cannot be the case that there is a 1000 Ohm resistor in both the starting setup and in the available parts.

Because the challenge mentions R1, I think it would be best to leave R1 in the starting setup, and remove the 1000 Ohm resistor from the available parts.

Thanks Floppy, luckily you caught this just in the nick of time and it’ll make it into the next production run of the books!